FS: 85 Mark II Parts

[azrael]

Cheap cheap cheap! Basically make me an offer -- it's either you take it from me, or it goes with the shell to the crusher.

Black 85 P type. Was in a front-end collision on the passenger side, so the right front fender, bumper, right corner light, and right fog are all fucked, as well as the grille and the header panel. The engine was run oil starved before I got the car, so there's a wicked top-end knock. I'm not sure what it is. Bottom end SHOULD be good, but don't quote me on that. Electronic timing, manual transmission. Tranny is nice and tight, brakes are pretty new. Body's got the typical rust spots, not the prettiest.

I've already taken the hatch, rear interior panels, door panels, rear seatbelts, and driver's side interior B pillar cover. Past that, it's got some notably good bits.

- Crackless, minty black dash pad with all vents
- Rear seats, grey cloth
- Passenger seat (driver seat has the usual rip in the side bolster)
- Alpine CD head unit. Looks like it has support for a changer and everything. Might even be built in? I have no idea.

Engine bits and things should all be there, but like I said, I don't know how good they are. If there's anything you can think of that you want, let me know and we'll talk.

[uncorkedsupra]

i am curious about the drivers side front fender, is it in good shape?
exterior body trim(the back stuff) do you have all of it?
rear fender flares, are they good?
the black rubbery bezel around the radio, is it still good?

possibly the intake and injectors??

did the gas gauge work well in this car? cuz mine does not work.
is the instrument cluster in good shape? non-digital?

i have not problem removing these parts, if you got some time.
how much would you be asking ($$$) for all this?

thanx
Carl.

[azrael]

Flares are gone, they weren't the best. (I stole all of the ones that weren't crunched. They were pretty chipped)

Radio bezel is there, but it's been chewed up a bit to fit the alpine deck that was in the car. Gauge cluster works, analog, gas gauge has worked well for me.

Exterior body trim? Like, the window trim, or the door mouldings and stuff? Window trim is pretty good, body trim is...there, but you'd have to straighten it out.

Driver's front fender is actually pretty good. Might need a little TLC, but it's all there.

Injectors and intake are good.

$30 for the lot?

[uncorkedsupra]

that sounds good,

i will say no on the bezel, cause mine is not totally bad, just not perfect,
if its still there the gas gauge sending unit inside the gas tank, i know how to take them out without dropping the tank?

how does 40$ sound.

the exterior side moulding is what i am after.
thanx.

[azrael]

$40 sounds fine for all that. Sending unit is still there.

I'll say again, the trim needs some love before it'll be straight and everything, but I'm fairly certain it's all there except for the front passenger fender trim. Some of that might still be on the car, but after being that crunched, I'm not sure you'd want it.

[uncorkedsupra]

sounds great, hold that stuff for me, i will pick it up later this week, when i know whats up with my car,

thanks.

carl

[Black_fin]

The noise sounds like a broken valve spring being tossed around in the drivers camshaft housing. It's a wonderful noise.

[azrael]

He made me stop standing on the gas pedal because it sounded so awesome. Andrew never lets me have any fun.

[uncorkedsupra]

dang, mine is sorta busted too, its got no power though, but everything else seems ok. it just does not go.

[uncorkedsupra]

i got it fixed, do you still have the speedo cable?

[azrael]

Speedo cable is in the car, yes. I have a few spares, too.

[suprago]

Interested in the dash and possibly some of the trim if still available.

[azrael]

Interested in the dash and possibly some of the trim if still available.

Still available. PM me or call me, 880-0851